Archive for October, 2009

Summary of an Atlas Resistance Push Pier

Wednesday, October 28th, 2009

The Atlas Resistance® Pier is a manufactured, two-stage product designed specifically to produce structural support strength. First, the Pier Pipe is driven to a firm bearing stratum; then the lift equipment is combined with a manifold system to lift the structure. The Atlas Resistance® Pier System procedure provides measured support strength. Atlas Resistance® Piers are spaced at adequate centers where each pier is driven to a suitable stratum and then tested to a force greater than required to lift the structure. This procedure effectively load tests each pier prior to lift and provides a measured Factor of Safety on each pier at lift.

Click on the link below to learn more about the Atlas Resistance Pier or to schedule a free foundation inspection and evaluation

http://atlasrestoration.com/foundationsettlement.html

Can My Sinking Foundation Be Repaired From The Interior?

Wednesday, October 28th, 2009

Workspace is not normally a problem when using Atlas Resistance Piers. They can be installed using portable equipment in an area that measures approximately three feet square. The pier may be installed from the interior or on the exterior of the footing.

Click on the link below to learn more about the Atlas Resistance Pier or to schedule your free foundation inspection and evaluation.

http://atlasrestoration.com/foundationsettlement.html

Crawl Liner Encapsulation vs. Concrete Crawl Floors

Wednesday, October 28th, 2009

I was recently asked about the pros and cons of crawl liners and concrete crawl floors. Considering that we have had many years of experience installing both of these systems I feel that Atlas Restoration is uniquely qualified to answer this question.

The main issues (i.e. problems) with pouring concrete in a damp and musty crawlspace are as follows:

1) Concrete does not effectively stop the musty smells (this is usually mold by the way)
2) Concrete does not effectively stop the moisture and humidity from entering the home.
3) Because concrete absorbs water (look at the dark spots in wet concrete sometime) it soaks up the moisture from the soils underneath it – effectively defeating the purpose of crawl space remediation in the first place!!! One technique to try and overcome this inherent flaw is to place plastic liner down before the concrete is poured. The problem with this is that the thin plastic liner tears quite easily when the concrete is put on top of it without the installer’s knowledge.
4) Concrete does not have any insulating benefits – it will cost the same to heat and cool your home after the installation of a concrete floor
5) The installation time for a concrete floor in a crawl space is not limited solely to the two or three messy days involved with the pumping process. Because the crawl space is already damp and musty, it can take weeks for the concrete to actually cure!
6) Unless it is heavily reinforced, concrete will always crack. It is not a question of if, but rather when the concrete will crack – sooner or later leaving the homeowner in the same situation they were in originally! A crack in the concrete lets in the same water, mold, mildew, bugs and soil that are inherent in an unprotected crawl space.
7) Believe it or not, with all of these issues concrete is usually significantly more expensive than a liner system.

For these reasons and more Atlas Restoration primarily installs Hydraliner crawlspace liners. Just some of the advantages of the Hydraliner are as follows:

1) Hydraliner does not absorb moisture
2) Hydraliner seals the crawlspace walls as well as the floor – keeping out rodents and insects
3) Hydraliner seals out the musty crawl space smells
4) Hydraliner completely insulates the crawlspace – virtually paying for itself in heating and cooling savings
5) Hydraliner will not crack or break
6) Hydraliner is tough and puncture resistant. You can crawl on it, service technicians can crawl on it, and you can store any item on it – transforming your former unusable crawl space into a clean, dry, and ample storage space for your home. The Hydraliner’s bright white finish actually brightens a crawl space with limited light, creating a friendlier storage environment
7) Hydraliner comes with a 25 year, fully transferable warranty!

Please visit the link below to find out more about the benefits of Hydraliner or to schedule a free inspection and evaluation of your crawl space

http://www.atlasrestoration.com/hydraliner.html

Is My House Sinking?

Tuesday, October 27th, 2009

I get asked this question all the time and chances are good that if anything, only a small portion of your home is sinking. Signs to look for are:
cracked drywall
cracked bricks or masonary headers
cracked sill plates
doors sticking
windows that don’t open properly

While these signs might not necessarily mean that the house is sinking, it makes sense to have one of our highly trained staff come out and provide you with a free evaluation.

To learn more about sinking homes or to schedule your free inspection click on the link below

www.atlasrestoration.com

Atlas Polyurethane Slabjacking

Tuesday, October 27th, 2009

Atlas Polyurethane Slabjacking is a process of injecting a high-density polyurethane under a slab to build up pressure and hydraulically lift the slab up to its original position.

To learn more about Atlas Polyurethane Slabjacking please click on the link below.

http://atlasrestoration.com/curling.html

Structural Foundation Repair

Monday, October 26th, 2009

Many commercial and residential buildings have become distressed due to settlement. This problem is often caused by weak or improperly compacted soils. Symptoms include:
drywall cracking
stair step cracks in brick
windows/doors that don’t operate properly
cracks in the foundation.

Click on the link below to learn more about structural foundation repair or to schedule your free consultation

http://www.atlasrestoration.com/foundation.html

How To Eliminate Concrete Slab Curling

Monday, October 26th, 2009

Movement is precisely measured at joints to assess severity of curling. Straight edges are also used to determine amount of curl. Movement greater than .015 inches is severe enough to cause deterioration three to four times as fast as normal.

Restoring sub grade support is the key to the repair.

Holes are drilled on each side of the joint where curling has occurred.
A High-Density Polyurethane Grout is pumped in under low pressure to fill voids beneath curled edges.

Surface restoration consists of removing the distressed concrete, reconstructing slab edges with polymer concrete and reestablishing the joint. These repairs often include grinding the surface to improve rideability and replacing damaged joint sealant material.

Work is most commonly done at night and on weekends to avoid disruption to normal warehouse operations.

Click on the link below to learn more about concrete slab curling or to schedule a free consultation:

http://www.atlasrestoration.com/curling.html

Concrete Slab Curling

Monday, October 26th, 2009

Curling is one of the most common defects found in floors, especially those in warehouses. Slabs curl upward at joints, saw-cuts and edges. This loss of sub grade support causes slab movement as forklifts pass over the joint. Joint edges deteriorate, cracks in the slab develop and wires embedded in concrete for automatic guidance systems may break. The amount of differential movement from one side of the joint to the other is directly related to the speed of warehouse floor deterioration.

Click on the link below to learn more about slab curling

http://www.atlasrestoration.com/curling.html

What makes the Atlas Battery-Backup Sump Pumps so unique?

Monday, October 26th, 2009

Location, location, location! That’s also key to the reliability of back-up sump pumps. Unlike other pumps, our pumps and their floats are placed out of the sump water.

Keeping the backup pumps and floats out of the water avoids continuous exposure to dirty water, mud, and debris. No clogging, mineral deposits, corrosion, or deterioration means maximum reliability and longevity of the backup system.

Our back-up sump pumps do not interfere with the primary pump or its float. Most residential sump pits are just too small for two full-size pumps. Installing a second pump inside a small pit makes it likely that the primary or secondary floats will get stuck or even entangled, taking both pumps out of action.

The discharge pipe connects to the main discharge pipe high above the primary check valve (2-4 feet). Other backup pumps are placed inside the pit right above the main pump. Consequently, the primary check valve is just inches above the main pump, where it is exposed to strong turbulence and constant pressure fluctuations. Such a stressed check valve tends to break or develop a hole. Once that happens, the back-up sump pump will just recycle water through the primary pump down into the sump pit and flood the basement.

The Atlas pumps feature a slim-line vertical float switch instead of a tethered float, which practically eliminates the risk of a stuck float inside a busy sump pit.

The suction pipe of our back-up pumps reaches to the bottom of the sump pit, so that it can fully empty the pit in each cycle. Other back-up sump pumps are installed above the main pump and do not have a suction pipe. They drain the pit only partially, resulting in short pumping cycles, more frequent starts, and a shorter service life.

Click on the link below to schedule your free sump pump inspection today

http://www.atlasrestoration.com/waterproofing.html

Is The Crack In My Basement or Crawl Space A Sign Of A Structural Problem?

Monday, October 26th, 2009

At Atlas Restoration we see thousands of cracks a year and the majority of these are not the result of structural movement.

Most cracks are simply shrinkage cracks that are subject to seepage but pose no structural threat to a home. Some cracks however, left untreated, can cause future severe damage to the structure. Some of the telltale signs that can accompany a structurally significant crack are: The crack is significantly wider at the top than at the bottom. The crack is offset, not on a smooth plane. Cracking in interior walls upstairs. Doors or windows won’t shut easily. Exterior brickwork is cracked or bulging. Floors are not level.

The link below will explain some of the permanent repair scenarios that are offered by Atlas Restoration

atlasrestoration.com/foundation.html